Runabout · step
Planning & Parts
Working out what to fit, what it costs, and whether it will actually fit.
Planning & Parts on every boat, not just the Runabout →
1963 Belmont Runabout I had seen this boat advertised in Boating USA for $20,000.00 and noticed it because it was in Spokane. About a year earlier, it showed up on Craigslist in Chattaroy with the price dropping from $13K to $11K, then $9K. I emailed asking for additional pictures and found out it was actually located in Elk, WA. I decided to check it out. It was sitting in a shop way off the grid, owned by a young man who decided that with two young kids, he didn’t need a wooden boat. He and his dad were very nice, though they didn’t have a lot of detailed knowledge about it. They thought i...
Stripping & Cleaning I removed the interior and gave it an initial scrubbing with Dawn dish soap, followed by leather cleaner and conditioner—the seats turned out great! Next, I removed the floor and side panels. After cleaning, the side panels came out so sweet that I plan to reinstall them as-is and lay down new marine carpet on the floor. The floors previously had vinyl over wood from an early 1990s restoration, along with evidence of tufted carpet at one point. I started polishing the windshield to see how much work it would require; it cleaned up very nicely, though it still needs atten...
Fuel Tank Restoration The dual 24-gallon fuel tanks mounted behind the seats developed a strong gasoline odor caused by missing vent lines and unvented replacement gas caps. Additionally, the fuel sending unit gave erratic readings because the float had sprung a leak. I drained 30 gallons of fuel, removed the tanks, and had Carlson Sheet Metal MIG-weld proper vent fittings onto each tank. After pressure-testing, I treated the rusted bottom of one tank with POR-15 tank sealer. Unfortunately, the POR-15 failed to adhere properly to the existing interior lining and began peeling. I had to un-se...
2024 Season Debut We kicked off 2024 addressing three final items: Fuel Tanks: Over-tightening hold-down straps had cracked the seam epoxy. I relieved strap tension, reinforced the corners with angle iron, and re-sealed them. Transom Leak: Delaminated transom plywood was prepped, saturated with penetrating epoxy, sealed, and fairing compound applied below the waterline. Carburetor: The old Edelbrock carb was gummed up from ethanol fuel. I replaced it with a new Edelbrock Marine 750 CFM carburetor. On the morning of August 12, 2024, we launched Usain Boat. Aside from waking up a few cranky...