boatbuildlog

Runabout · step

Engine & Propulsion

Repowers, jack plates, props, kicker brackets, fuel system changes.

Engine & Propulsion on every boat, not just the Runabout →

1
Builders
3
Entries
30.0
Median hours

Upgrades & Electronics The electrical wiring harness was in terrible shape; bending the wires caused the insulation to crack and flake off. I ordered new marine-grade wiring and cables, along with heat-shrink, waterproof connectors. I also ordered a couple of replacement gauges to match the original Stewart-Warner units. I completed the engine hatch modification by centering it in the opening and cutting it cleanly in half using a Bosch jigsaw with a new fine-tooth blade at 0°. I built support frames for both halves, then bored a 3/4" hole to accept a brass bushing, stainless steel bolt, and...

Read in context →

More Photos, start of engine repair

Read in context →

January – Summer 2021 With the bottom paint complete, I sanded the 9 coats of varnish with 400-grit sandpaper at low speed to flatten the surface. Working in a 55°F shop (below recommended application temperatures) created "micro-runs" that required careful leveling. I followed up with 600-grit paper and light coats of clear gloss varnish prior to final buffing. When COVID-19 restrictions closed the shop in February 2021, Usain Boat went into temporary storage. Once the school year wrapped up in summer 2021, I unpacked the Belmont to prepare for its maiden lake cruise. Unfortunately, things...

Read in context →