boatbuildlog

Tiny Titan · step

Hull Panels

Scarfing plywood, cutting panels, milling strips or planking stock.

Hull Panels on every boat, not just the Tiny Titan →

1
Builders
6
Entries
11.5
Median hours
Matt 11.5 h

Today I started to get the garage ready and started to prep for cutting out the frame. I cut the bottom plank using the table saw, and the frame timber by using the jigsaw.

I didn't get a lot done because I spent time reorganizing the garage and bringing some of the heavy tools in from the shed.

It is also 105° here in Dallas Texas area so I've decided I'm going to install a couple fans.

I use this little RC propeller to trace the lines from the tracing paper to the lumber it actually worked pretty well.

Read in context →

Okay so I have cut out all the pieces for frame #2. The bottom member or crossmember I accidentally planed that down to 1/2 in and so things were not fitting correctly so I scrapped that wood and recut a new piece as that particular piece needs to be 3/4" thick, which was the actual thickness of the wood that I bought so I did not need to plane anything.

I've got to say, this would be a tough job without a planer. Unless you are lucky enough to get the wood in the correct dimensions, you might need to purchase a planer. It saves so much time being able to get it down to the 1/2" that you ne...

Read in context →

Morning Progress

Cut out a few more pieces:

  • Side planking
  • Runner chine
  • Bottom battens

Note on the bottom battens: I bought 1x2 timber at the store but forgot it's not actually 2 inches — it's more like 1¾ in. I ended up planing everything down to ½ in, so the final dimension is ½ x ¾ in instead of the original spec. Should still be plenty strong.

Current Status

  • Waiting on bronze nails to ship from Glen-L before I can start assembling anything
  • Honestly feeling pretty lost on the build right now — I've stared at the plans for a long time, looked at pictu...
Read in context →

I think at this point in the build I'm just getting comfortable over the fact that I've probably made mistakes and nothing seems to fit perfectly. I have stare at the plans countless times and I still don't understand how some of the pieces are off in some cases about an inch. I know the one mistake I made which was cutting the AFT side too short by 2 in, that one was on me. But the rest I would expect should all be within reason.

Anyway, today I glued on the chines. Technically the plans say to put the chines on the side planking and then mount it to frame one and then mount everything...

Read in context →

Today I put on the sheer clamps and mounted them to the side panel. The sheer clamps are 3/4 in by 3/4 in so I basically took a 1x2 and cut it right down the middle. I also had to cut out a little bit more in those grooves so that the plywood would correctly set on the bottom panel, it does not have to be perfect as this is what fillets are for. Anyway, so all I really did today was glue the sheer clamp and tomorrow I think I will finish mounting the sheer clamp to frame number one and frame number one to the actual boat.

Read in context →

I spent a few minutes this morning just clamping on the bow pieces. There is about a one foot section of the bowel that gets an additional one quarter inch plywood. Pretty straightforward.

Oh and I accidentally broke the sheer clamp, so you can see the Band-Aid I've got going on here.

Update: because it's so hot here in Texas everything blues within an hour and it's strong within 4 hours. I came back in later tonight and I glued and nailed frame number one in place. Because I had the measurements wrong on the batten I had to fix to it another piece and glue that together, that's why it...

Read in context →