already put trusses on it length of my trimaran sailboat with engine is 31feets. high is 32inches from bottom to top
Read this entry in the log → Hull Panels on every Custom 31 ft Trimaran →Hull Panels
Scarfing plywood, cutting panels, milling strips or planking stock.
60 entries from 16 logs, newest work first.
My brother and I started working on the hull around 9:30 this morning. We worked our way from panel to panel. Panels 3 & 4 still needed a bit of sanding. Cause this panels are so long we just put them on the floor of the garage for sanding. I kept some of the...
Read these entries in the log → Hull Panels on every Northeaster Dory →Assembled all panels. Sanded smooth prepare for assembly.
Read this entry in the log → Hull Panels on every Northeaster Dory →Had hull panels cut out by Chesapeake Light Craft from 4mm okume plywood. Rails are 1/4 x 3/4 solid sapele. Boat length ~93 in, so all panels would fit in a single sheet of plywood with no scarf. In retrospect, I should have spent more time making some of the...
Read this entry in the log → Hull Panels on every Micro-Wherry →Getting ready to add the bottom panel. Adding a bit of wood in the bow area to ensure that I can get a good wood screw purchase along the chine. Currently debating the method for creating a butt block to join the fore and aft panels that go on the bottom
Read this entry in the log → Hull Panels on every Flying Saucer →I spent a few minutes this morning just clamping on the bow pieces. There is about a one foot section of the bowel that gets an additional one quarter inch plywood. Pretty straightforward. Oh and I accidentally broke the sheer clamp, so you can see the Band-Ai...
Read these entries in the log → Hull Panels on every Tiny Titan →I bought a kit for the whole boat. It saves time and add some precision. I am building it in a single car garage. It is tight, with a total of 6 inches of clearance at the ends. My « workshop » is in the basement under the garage, this is where I made the k...
Read this entry in the log → Hull Panels on every Didi 26 →So I’ve been making the transom recently which consists of two layers of 1/2” ply and two more layers for the “frame” . Glued/filleted on the cleats for cockpit seats, transom stiffeners and propane locker, you’ll also notice a few holes for tiller, cockpit dr...
Read this entry in the log → Hull Panels on every Eland 36 →Two big boxes full of parts and pieces.
Read this entry in the log → Hull Panels on every Passagemaker Take-Apart →Filled low parts of bow with thickened epoxy and leveled. Basic shape all that's needed at this point with plenty of fiberglass and fairing ahead.
Read these entries in the log → Hull Panels on every Bahia 12 →Any stitch-and-glue boat beyond 8' long requires two or more carefully shaped plywood pieces to be glued together to form one long strake. Pygmy used to use just flat butt joints. CLC uses puzzle joints, which facilitate aligning the planks lengthwise and hold...
Read this entry in the log → Hull Panels on every The Guider →Boat Building Log Phase 1: Unpacking & Inventory The very first phase of building this boat involved unpacking the kit and doing inventory on all the parts. Thankfully, everything was well marked, so it was really just a matter of getting out the panels and se...
Read this entry in the log → Hull Panels on every Northeaster Dory →