14 ft Rapid Robert · step
Hull Panels
Scarfing plywood, cutting panels, milling strips or planking stock.
Hull Panels on every boat, not just the 14 ft Rapid Robert →
Our Project began last week when Mack's Dad, Tom, dropped by with 4 wonderful sheets of 3/8 Okoume Plywood and a nice sheet of 3/4 inch Douglas Fir for the Transom. Thanks Tom! Mack and I quickly ran out to purchase our studs for the ribs. We elected to use Douglas Fir 2x4s which we planed down to 2.5x1.25 stock. We then cut, beveled and joined the pieces to form our seven ribs, which at 1.25 inches should be plently strong. We chose to taper our ribs as they approach the gunnels to give the boat a lighter look. The ribs were joined using a 5/8 inch notch to join the floor pieces to the sidewa...
Probably the most exciting day so far, yesterday we cut and attached the floor! Before we began Mack routered out scupper holes in each of the ribs, we kept them small to limit the pace at which water can flow around the boat. Next up was the 2nd Scarf Cut. We rigged a jig for the circular saw in the driveway, it was not pretty but it got the job and done after a few attempts we had a nice cut. We decided to scarf and join the plywood on the boat rather than joining the wood, letting it cure for a day and then cutting it to fit. We were able to use one piece of plywood for the floor section fr...
Hope you caught that "Airplane" reference, If not no worries lets move on. Alright so as you can see, the sides are cut and ready to be joined. we begain with the center rib and moved out from there, so rib 4, then 3&5, then 6&7 and lastly the stem. Each rib was slathered in West System Fast Curing Epoxy and then tacked to the walls using a nail gun for placement . Then we used 1.25in stainless screws for fastening. We clamped a piece of scrap to the bottom of the rib to ensure the bottom edge of the wall was flush with the bottom edge of the rib. I wish we had more photos of this assembly but...
Well, a lots happened since we last left off. After the ribs cured, Mack got to work during the week on a few things to keep us moving. He notched the ribs for the Chines, made the transom cut from our 3/4 in. Fir, attached Rib 7 to the transom, and clamped and glued 2 of our leftovers planed studs together to use for the stem, saving us the need for a 4x4 piece. More importantly, Mack scarfed the two plywood sheets together for the sides at his shop, as the weather was not ideal for outdoor curing. To make the scarf cuts, He made a jig for the 7.5 in circular saw. It actually worked quite wel...