boatbuildlog

The Guider · step

Rig & Spars

Mast, boom, standing and running rigging, sails.

Rig & Spars on every boat, not just the The Guider →

1
Builders
3
Entries
n/a
Median hours

There is a yard and a boom for the Guider. The sail is laced to the yard but is loose-footed at the boom. Both spars are solid and built from glued pieces of solid wood; in my case, cypress supplied with the kit. The tapers for each were marked with full-size templates supplied by CLC and then cut with a bandsaw. After cutting the tapers into the blanks, the final profiles were worked in with hand planes. I owe much of the success of spar building (and many other things) to a good woodworking friend who has the gear and expertise. In exchange, I take him sailing. I think it's a win-win situati...

Read in context →

The yard and boom were sealed with two coats of epoxy, then primed and painted in two colors (Donegal Green and Mediterranean White). Where I grew up, this was a common color scheme for boats that weren't playthings for the rich and famous. I always liked the way it looked. I switched to the darker Interlux primer in the hope I could get full paint coverage with fewer coats. I almost could get away with 2 coats of paint, but in the end needed 3, just like everywhere else.

Read in context →

The 17' mast on Kembali is a hollow box with solid plugs on either end. The staves are scarfed from 3 pieces of solid timber, into which the tapers are cut from templates supplied by CLC. Then 3/4" rabbets are cut into both interior sides of the front and back staves. The side staves are glued into these rabbets, and the solid end plugs are emplaced during final assembly. Finally, all four edges of the mast blank are rounded over with a router, and a slot is cut in the peak to accept the halyard sheave. It's all incredibly easy to do....not. There are a lot of pictures here showing most of...

Read in context →