boatbuildlog

Micro-Wherry · step

Fillets & Taping

Epoxy fillets, taped seams, structural joints.

Fillets & Taping on every boat, not just the Micro-Wherry →

1
Builders
5
Entries
17.5
Median hours
Dave 17.5 h

Removed port side stitches. Realized I went a little too heavy on some of the CA glue when some stitches wouldn’t come out. Sanded everything flush, wiped with alcohol, dry fit tape. Added fillets, cured for ~2hr. Put tape in sticky fillets, and wet out. The lower 2 seams have a little too much epoxy in the center 2ft or so of the boat, and one area on the tape self-edge is starved, but I will sand off when I feather. Learned not to try to wet all tape at once. Next time will do bottom two, then top one. Also turned over, removed other stitches, and sanded other side smooth and wiped.

Read in context →

Added fillets to inside of starboard seams. Went a lot smoother this time thanks to experience from last time. Took less than 30min to mix and fillet whole side.

Tape was “dry” laid on tacky but hard-ish fillets, they wetted out. Smoother than yesterday, but still took over an hour for 3 tapes.

Read in context →

Filleted and taped the front 7/8 of the boat with the bow down, waited an hour, then filleted and taped the transom and rear foot of the keel line with the stern down.

I used a bunch of CA glue in all the seams to try to avoid panels popping out and needing a re-glue, but the front bottom corner still popped out, so I put two zip ties in and left them. Still a bunch of my thickened fillet epoxy came out that seam, which left a bit of a mess on the outside that will mean more sanding for me. My build process goal this time was to avoid making mistakes that would lead to unnecessary sanding....

Read in context →

Gave the garage a much needed cleaning. I have been saving the pile of zip ties and at this point they are all out (or cut down and sanded in) except one through the bow, so the pile was as big as it was gonna get.

Sanded all external seams smooth. Still a couple “steps” at the bow where the panels didn’t quite meet perfectly, and I haven’t yet sanded the concave portion at the back. But everything else is looking pretty good, almost ready to tape the outside

Read in context →

Taped outside seams, ran out of tape so did seams from bottom going up. Upper ones (hopefully) should take a little less abuse and are shallower in angle, so I think I will get better adhesion with cloth anyway.

Sanded down all tape self-edge and feathered(ish) into the plywood panels. Found a couple of small voids and sanded smooth, not too worried about those.

Sanded panel overlaps on transom down and rounded edge over. Cut “handles” of outwhale outside the transom. Rounded off outwhales at the bow. Sanded all excess resin off external surface of outwhale.

Laid and cut single hull...

Read in context →