Fillets weren't too challenging although there wasn't much of a fillet along the bottom panel were it meets the deck panel. I would use a bigger radius fillet stick if I were to do it again. Tape was easy to apply but not so easy to remove later.
Read this entry in the log → Fillets & Taping on every Northeaster Dory →Fillets & Taping
Epoxy fillets, taped seams, structural joints.
15 entries from 8 logs, newest work first.
Taped outside seams, ran out of tape so did seams from bottom going up. Upper ones (hopefully) should take a little less abuse and are shallower in angle, so I think I will get better adhesion with cloth anyway. Sanded down all tape self-edge and feathered(ish...
Read these entries in the log → Fillets & Taping on every Micro-Wherry →Fatal mistake today! When I was about to do one of the last fillets I took hardener instead of epoxy and vice versa. Yep, it did not cure. Don’t know how this could happen. Every batch before I took so much care choosing the right container but finally it happ...
Read these entries in the log → Fillets & Taping on every Northeaster Dory →Put in the final fillets for the transom and Stern pieces. Once these dry I will give everything a very thorough sanding to make it much smoother before I flip it over and start to prepare the bottom.
Read this entry in the log → Fillets & Taping on every Tiny Titan →After removing all the stitches, the boat was strictly held together by wood glue only. I fill it at the inside of the planks with wood flower and resin. After grinding down the rough fillets on the inside. I laid out the 4 ounce fiberglass cloth on the inside...
Read this entry in the log → Fillets & Taping on every Ultralight Dinghy →Phase 6: Filleting the Seams After you finish tack welding and remove all the stitches, the next step is filleting. On the bottom panel, where it connects to each of the bulkheads, and along the bottom and side panels, you need to run a fillet: a small bead of...
Read these entries in the log → Fillets & Taping on every Northeaster Dory →Phase 2: Transom, Fillets, and Fiberglass In this next step, I fit the transom, again using the stitch and glue method, running wires through to secure the transom to the hull. Next, I added the fillets. Small fillets go in between all of the copper wiring fir...
Read this entry in the log → Fillets & Taping on every Polliwog 8 →Houseboat update, Thursday, April 18, 2019 -- I beat the anticipated rain today, completing the major part of the shaping of two of the four additional support posts I will need to start work on Jersey Girl's aft deck roof and aft cabin wall. They are made of...
Read these entries in the log → Fillets & Taping on every Jersey Girl →