boatbuildlog

Micro-Wherry · step

Stitch & Assembly

Wiring or clamping the hull together and getting it fair and true before glue.

Stitch & Assembly on every boat, not just the Micro-Wherry →

1
Builders
3
Entries
5.0
Median hours
Dave 5 h

Stitched all hull panels with zip ties. Ran out of zip ties and had to run to the hardware store. Stitching took a lot longer than I thought - last time I had ~20ft of seams on a 5ft boat from 2-plank hull shape, this one has ~60ft on an 8ft boat from 4-plank shape.

Next time I would definitely shell out for a sheet of big box store plywood to use as a nice big table, working in the floor for the first 2hrs until each side was stiff enough on its own to bridge the sawhorses was painful.

Read in context →

Went through boat and cinched all zip ties taut, then went through again and (where needed) cinched all zip ties tight. I bought a saw where before I had borrowed others. I used it to cut the tips off the overhanging front outwhale, allowing the top planks to meet flush at the bow. Also used saw to cut spare stick stock to make thwarts to seat correct beam of the boat. It looks a bit wide, and I may play around with this a bit later. Initial plan was to exclude thwarts from final design, but may change that plan if the boat doesn’t get significantly more stiff with fiberglass.

Most gaps cl...

Read in context →

CA glued all seams. Went heavier on the glue. Was told it might pop out, and wanted to prevent that, especially in high stress areas. The way I tilted the hull induced a very slight twist, which I can live with but would rather not, so I’ll try to “de-twist” by reversing the direction of the single support in the next step.

Read in context →