Over the course of October, I assembled the hull and fibreglassed it inside & out. Knowing some more modern stitch & glue building techniques by now, I put the manual aside and assembled the hull slightly different: Silica-thickened epoxy for joining the pane...
Read this entry in the log → Stitch & Assembly on every Shearwater Sport Hybrid →Stitch & Assembly
Wiring or clamping the hull together and getting it fair and true before glue.
26 entries from 9 logs, newest work first.
Not to much done today. I pulled out all the wires. Only the once in the bow, the bulkheads and the transom remain. With the help of my wife and Liz we turned the hull around again. I had to sand only this tiny area in the stern. The rest was all good on the i...
Read these entries in the log → Stitch & Assembly on every Northeaster Dory →Stitch using copper wire. I slightly rounded the bottom and first panel to make them assemble easier. The transom assembly was extremely difficult. DFM wasn't really considered by CLC and I resorted to heavy .041" stainless steel aviation safety wire to get...
Read this entry in the log → Stitch & Assembly on every Northeaster Dory →CA glued all seams. Went heavier on the glue. Was told it might pop out, and wanted to prevent that, especially in high stress areas. The way I tilted the hull induced a very slight twist, which I can live with but would rather not, so I’ll try to “de-twist” b...
Read these entries in the log → Stitch & Assembly on every Micro-Wherry →Glued on some more of the transom frame
Read these entries in the log → Stitch & Assembly on every Tiny Titan →After cutting out all the parts with the router. I carefully laid out all the planks in the correct order right, left, ins, and outs. I didn't use copper wire, I used less the expensive soft steel baling wire for the plywood stitches that I got from Home Depot...
Read this entry in the log → Stitch & Assembly on every Ultralight Dinghy →The main deck is built up from three pieces per side, with puzzle joints and epoxy. Then the two sides are mated along the centerline. Finally, both sides are fiberglassed with 3" overlaps in the cloth. I used peel ply fabric on the upper side to get a nice sm...
Read these entries in the log → Stitch & Assembly on every The Guider →Phase 3: Stitching the Hull This next step is a two-person job, so you'll want a helper. This is where the bulkheads get assembled onto the bottom piece and all of the side pieces, tying everything together with metal wiring. I used thin copper wire to stitch...
Read this entry in the log → Stitch & Assembly on every Northeaster Dory →Phase 1: Lofting and Cutting the Main Panels This was my first boat, so if you spot things that look wrong in the pictures, go easy on me. This was also my first time lofting. Overall, I'm pretty happy with how the process went. Lofting itself was relatively e...
Read this entry in the log → Stitch & Assembly on every Polliwog 8 →