boatbuildlog

Grey Seal · step

Hull Panels

Scarfing plywood, cutting panels, milling strips or planking stock.

Hull Panels on every boat, not just the Grey Seal →

1
Builders
4
Entries
n/a
Median hours

this project was started in about 2012. I'll post as many original photos as I can find, hopefully in chronological order.For commentary please provide your own 'cos Ive forgotten it. Once i catch up then talking will be attached again. Please forgive any pics not up the correct way.Stock made up of ply web beams from builders supply, available in really long straight lengths.Laminated frames held onto moulds with small blocks

For and Aft stems in position

Glue up of keelson, in position hence plastic. Later finished on bench and centre-board slot cut in.

Glue in of keelson. Planing of beve...

Read in context →

Next pic shows my spiling plank made with “hinges” out of MDF strips. REason for two lines along bevel was to show when i was getting close to final width by “disappearing” first line. I never was very successful at getting out a plank straight from spiled, so i just roughed in the lower edge of plank from Spiling then held it in position, transferred bevel line across, marked underside for upper edge of planks. Iain Oughtred supplies planking layout lines on his plans.

This first photo shows where i applied some new edges to these planks to bring the edge into line and fair. Screwed-on Batte...

Read in context →

Well I’ve decided on cut layout for remaining sheets of ply and it looks like I might make it, barring any whoopsies. So all up I’ve used 20 sheets of 1/2” , 3 or 4 sheets of 3/8”(interior cabinets and bunks) , 4 sheets of 1/4” ( cabin roof).

Above are are all deck pieces layed out with scarf allowance, just for OCD satisfaction I’ve lapped the scarfs from bow to stern. In the end it doesn’t take much to cut each scarf just some noise and dust. At one stage I was considering butt joins but Ian Milne talked me out of it thankfully.

Read in context →

Hi there, well thankfully the fires didn’t come this way ...... yet anyway. In the heat things area bit slower than usual. But over the last week I’ve managed to get the rubbing strokes on. First layer is 45x16 tapering to 35x16 at the last 2 meters. Used Merbau decking which has turned out really well (halfway sensible price too) Steamed the last 3.5 meters to get it around the stern. I epoxied the flying surfaces and then stuck it on with Sika291 and screws. The second layer I used 35x14 tapered again at the ends with a bit of a round over. Once again epoxied the flying bits and used 291 aga...

Read in context →