boatbuildlog

Grey Seal · step

Interior & Cockpit

Bulkheads, seats, buoyancy, sole, storage.

Interior & Cockpit on every boat, not just the Grey Seal →

1
Builders
3
Entries
n/a
Median hours

Today a minor milestone , glued the cabin sides and front in. Means I have to find another way aboard !

Read in context →

Last few days have been a boat building adventure. I got the lid on! Well half of it anyway, gives a really different feel to cabin. Next photos show two 1/4” sheets laid athwartships, glued and screwed down also about 100 plastic nails. Happily it looks like only about three have missed the mark and come through inside so there’s a bit of patching coming up along with the final finish inside cabin.

To hold down edges of roof sheets while I screwed them I setup some clamp blocks that are in turn clamped to side of cabin through portholes.

Ive also had the varnish brush busy too putting some...

Read in context →

Time for an update I think cos engine stuff is slowed waiting for bits. I’ve started constructing the cockpit lockers so that the fuel tank has a home and the engine control lever gets fitted into the opposite locker on port side.

this is the starboard locker with a piece of MDF screwed onto side deck Carlin at the angle of seat back which also curves in planview. I had to project the angle of the future 12mm sea back down to seat level so I cut a pointer stick of a thickness which gave the line of front surface so that I could plan where the rear hinged lip of locker lid goes.

I think on th...

Read in context →