boatbuildlog

Spartan II · new build

19' Gaff Sloop Centreboarder, based on a design by Paul Gartside

by Dale Simonson · Victoria, BC · Message Dale Simonson

A much bigger boat for us... for the last 14 years since I built and launched her, we've been cruising on our 12' Welsford Scamp LUNA. This is going to be fun!

Make a book Feed The whole log, 2 entries and every photo, laid out as a book to print, bind and keep.
20
Entries
73
Hours
151
Days elapsed
75
Photos
Jan 2026
Started

See Shop & Tooling on other boats →

Shop & Tooling · other boats 7 h Link

Purchase and rip cedar for strip-built hull

The design calls for strip planked, 3/4" by 1-1/4" Western Red Cedar, glassed inside and out. We found some very tight-grained 2x4 green material at a local building supply, and purchased 17 10-footers and 17 12-footers. They'll have to be scarfed to achieve our desired length, a little over 21 feet. Totally stunning wood... there isn't much of this stuff left in our forests, so, worth every penny of their ridiculously expensive price!

Ripped it down to 3/4 by 1-1/2" ...a bit wider than the plans, but a much better cut out of the material. We'll see how difficult it is at the turn of the bilge, and perhaps have to rip a few in half at the sharpest turn. Then stickered and stacked them up in the shop rafters to air dry.

1 Spartan II: Purchase and rip cedar for strip-built hull
2 Spartan II: Purchase and rip cedar for strip-built hull
3 Spartan II: Purchase and rip cedar for strip-built hull
4 Spartan II: Purchase and rip cedar for strip-built hull
5 Spartan II: Purchase and rip cedar for strip-built hull
Shop & Tooling · other boats 4 h Link

Recycling Church Pews for our New Boat

The church pew seat backs have a gentle curve, quite comfortable to sit against. We first ripped them down their gluelines to separate them into their original planks, then ran them through the jointer to remove the cup (and finish), then through the thickness planer to complete the flattening.

Next, we resawed and planed once again, to 1/4" thick, for laminating onto ply for cabin sides and transom. Such beautiful wood!

1 Spartan II: Recycling Church Pews for our New Boat
2 Spartan II: Recycling Church Pews for our New Boat
3 Spartan II: Recycling Church Pews for our New Boat
4 Spartan II: Recycling Church Pews for our New Boat
5 Spartan II: Recycling Church Pews for our New Boat
6 Spartan II: Recycling Church Pews for our New Boat
7 Spartan II: Recycling Church Pews for our New Boat
8 Spartan II: Recycling Church Pews for our New Boat

Nobody else here is logging a Spartan II yet. See the boat.