boatbuildlog

Runabout · modification

Usain Boat

by Alan Wardsworth · Spokane Valley, Washington · Message Alan Wardsworth

1963 Belmont runabout 19'

Make a book Feed The whole log, 6 entries and every photo, laid out as a book to print, bind and keep.
23
Entries
200
Hours
n/a
Written up afterwards
437
Photos
Mar 2020
Started

See Finish & Cosmetic on other boats →

Finish & Cosmetic · other boats 10 h Link

Steering Helm Upgrade As temperatures warmed up, the steering wheel became nearly impossible to turn due to a failed 20-year-old cable and helm. I replaced it with a SeaStar Teleflex (SSX17617) Tilt Xtreme NFB 16 ft Rotary Steering Cable & Helm Kit, which mated perfectly with the stock steering wheel. I decided not to activate the horn for now due to the difficulty of drilling through the dash for wiring, though the cable is routed if I decide to hook it up later. October & November Updates I refinished and reinstalled the engine cover with fresh paint and varnish, installed new Stewart-Warner gauges, and scored a great deal on original gas caps on eBay. During a test fire after rebuilding the carb, the battery went dead because the igniter wire had come loose at the starter. I also located the original stain formula: Bamboo Mahogany, which features a rich dark tint with subtle purple undertones. In November, I moved the Belmont to the school shop to work on it and use it as a project for virtual boat-building sessions on Wednesday nights. We lifted the hull off the trailer onto shop dollies and discovered significant damage on the sides behind the wheel wells. We prepped the area, laid down new fiberglass corners, and restored incredible strength to the structure. After it cured, I sanded it smooth and applied light layers of polyester fairing compound across the corners and bottom. Minor dings on the topsides were filled as well. December Stripping & Refinishing I stripped the hull sides using three generous coats of TotalBoat Stripper. The varnish lifted in about 15 minutes, while the underlying fiberglass resin required two coats and an overnight soak to dissolve. Areas that had never been exposed to sunlight remained very dark and required hand scraping and sanding down to bare wood. Because the mahogany veneer was paper-thin in places, it appeared this hull had been stripped at least once before. With the bare wood exposed, screw holes were filled with mahogany Famowood filler (or solid mahogany plugs where structural strength was needed). I applied Minwax Bombay Mahogany stain to recreate the original dark purple-tinted hue, followed by a heavy coat of penetrating sealer and 9 coats of clear marine varnish before dry sanding.

1 Runabout: finish & cosmetic
2 Runabout: finish & cosmetic
3 Runabout: finish & cosmetic
4 Runabout: finish & cosmetic
5 Runabout: finish & cosmetic
6 Runabout: finish & cosmetic
7 Runabout: finish & cosmetic
8 Runabout: finish & cosmetic
9 Runabout: finish & cosmetic
10 Runabout: finish & cosmetic
11 Runabout: finish & cosmetic
12 Runabout: finish & cosmetic
13 Runabout: finish & cosmetic
14 Runabout: finish & cosmetic
15 Runabout: finish & cosmetic
16 Runabout: finish & cosmetic
17 Runabout: finish & cosmetic
18 Runabout: finish & cosmetic
19 Runabout: finish & cosmetic
20 Runabout: finish & cosmetic
21 Runabout: finish & cosmetic
22 Runabout: finish & cosmetic
23 Runabout: finish & cosmetic
24 Runabout: finish & cosmetic

Nobody else here is logging a Runabout yet. See the boat.