More Photos
Runabout · modification
Usain Boat
1963 Belmont runabout 19'
See Finish & Cosmetic on other boats →
More Photos
July Updates After finishing the bilge paint, I rewired the entire boat to eliminate the automotive connectors, spliced wires, and cracked insulation. BestBoatWire.com was a great source for 16 AWG marine wire in various colors. Working from aft to fore, I tackled the dash last; running one wire at a time and bundling them neatly turned out to be the cleanest approach. Wiring the one-wire marine alternator and installing a functioning ballast resistor took the most research. Next, I pulled up the old vinyl flooring and laid down taupe marine carpet. (It appears the boat originally had light gray carpet, followed by green AstroTurf, then beige vinyl in the mid-1990s). I also replaced the steering helm because the old one grew increasingly stiff in warm weather. Engine & Mechanical Setbacks After checking all fluids, I turned the engine over a few times without ignition to build oil pressure across the bearings and ports. Once verified, I connected the coil wire—and it fired up for the first time in 2 to 3 years! When I hooked up a garden hose to supply cooling water, it started right up, though it briefly stalled due to an alternator wiring mistake and a faulty ballast resistor. Once corrected, it ran smoothly for 10 minutes after a quick carburetor adjustment. However, when I shifted into gear and the propeller shaft began to spin, it started squeaking. I shut it down immediately, only to see the transmission blow a "strawberry milkshake" out of the vent. Both Glenwood engine and transmission oil coolers had failed internally, dumping cooling water directly into the oil of both systems.
More Photos
More Photos
Nobody else here is logging a Runabout yet. See the boat.