Starting to epoxy the interior, it's getting a bit hot in the garage so I'll stop for today. We have some more surfaces but probably I am about 70% done.
Tiny Titan · new build
Glen L Tiny Titan Hydroplane
Building a small hydroplane for the kids to learn some basic boating skills on a fun boat!
See Glassing & Epoxy on other boats →
I put on the second coat of epoxy for the entire interior. Tomorrow I will do a sand of the interior and prep for paint and primer.
Today I applied the fiberglass to the bottom of the hull. This actually went a lot smoother than I thought it would, but this is like the third boat that I've fiberglassed, so I think I'm finally figuring how to do it correctly.
I'm using a new epoxy and hardener, something different than I've previously used. So far it is more smelly but it seems to be a little bit less thick than the previous one, which makes it pretty runny. Fortunately I was able to squeegee out most of the excess so it actually looks pretty good and I won't have to do a ton of unnecessary sanding.
After this dries I will send everything down and then apply an additional layer of fiberglass tape along the sides of the hall. I also have yet to do the transom, so I will do that at the same time.
Nobody else here is logging a Tiny Titan yet. See the boat.
What it cost
$1,966.00| Item | Qty | Supplier | Cost |
|---|---|---|---|
| Boat Plans | 1 | Glen-L | $75.00 |
| Ryobi Plug-in jigsaw | 1 | Home Depot | $100.00 |
| lumber | 1 | Home Depot | $100.00 |
| Fir AB Marine 1/4" 4x8 | 2 | Plywood company | $200.00 |
| Fir AB Marine 1/2" 4x8 | 1 | Plywood company | $137.00 |
| Birch 1/8 4x8 Plywood | 1 | Plywood company | $35.00 |
| Craftsman planer | 1 | Home Depot | $329.00 |
| Fasteners and Fiberglass kit | 1 | Glen-L | $400.00 |
| 6oz Fiberglass Cloth Roll | 1 | Amazon | $15.00 |
| 6HP 2 Stroke Hangkai Outboard Engine | 1 | Hangkai | $575.00 |