boatbuildlog

Northeaster Dory · new build

Northeaster Dory to be assembled in Cologne Germany

It is the first boat I build. I‘ll do it in my single garage and partly in my cellar.

Make a book Feed The whole log, 2 entries and every photo, laid out as a book to print, bind and keep.
23
Entries
121
Hours
32
Days elapsed
65
Photos
Oct 2026
Started
Watch the 30 second boat build video

The film on its own page

See Stitch & Assembly on other boats →

Stitch & Assembly · compare · other boats 4.5 h Link

Stich & GLUE!

I used some spacers, a carpenter once gave me, to level the base of my terras, to open the gap at the bow end of panel 1.. Working with the pastry bag was a good experience. When I am done with the Dory I am ready for some nice cake! It was kind of tricky to hit the right mixture of thickened epoxy. At the end I got pretty good at it. After each panel I glued I took a look to the inside and just found very few running epoxy. Of course I thought I could work that good, that not a single wire has to remain in the hull - guess what - I didn’t manage that. I did one batch with about 300ml in one pastry bag. That was kind of hard to handle. I recommend a maximum of around 200ml per bag. That allows you to twist the end of the bag and give it a knot (a plastic clip from the kitchen could work as well) Barely forgot to tell that I found around 50ml of the 300ml batch on my shoe after I stopped holding the end of the bag that was just twisted. I guess I needed the hand to stop some running epoxy - can’t remember. Now my Redwing Shoe is watertight forever.

1 Northeaster Dory: Stich & GLUE!
2 Northeaster Dory: Stich & GLUE!
3 Northeaster Dory: Stich & GLUE!
4 Northeaster Dory: Stich & GLUE!
Matt 3 weeks ago

Everyone leaves some wire in the boat, whether they tell you they did or not ;-)

Stitch & Assembly · compare · other boats 4 h Link

No more copper wire

Not to much done today. I pulled out all the wires. Only the once in the bow, the bulkheads and the transom remain. With the help of my wife and Liz we turned the hull around again. I had to sand only this tiny area in the stern. The rest was all good on the inside. Before I didn’t have time and clamps to glue other parts so I did the skeg, the dagger board and the rudder today. The masking tape is attached an I measured and cut the fiberglass cloth. I‘d say all of this took me 4 hours. Ahh forgot to tell that I had to buy more sanding paper (80 grid) and more brushes.

1 Northeaster Dory: No more copper wire
2 Northeaster Dory: No more copper wire

Others building the Northeaster Dory

The same boat, in somebody else's shop.

All Northeaster Dory logs, with the medians