Dash board work
I couldn't find any mahogany wide enough for the dash that was priced reasonably. So I resorted to a glue up using biscuit joint technique.
Malahini · new build
2nd boat build, 1st was a cedar strip canoe, planning on a kayak build after the Malahini.
I couldn't find any mahogany wide enough for the dash that was priced reasonably. So I resorted to a glue up using biscuit joint technique.
Installing the dash was challenging to get the cuts right for the carling. The holes for instruments and steering have not been cut yet. That will be decided later after the outboard and the controls for it are purchased.
Framing up the rear deck and motor well area.
Epoxy seal for the motor well
It's time to seal up the floor and sub structure. I used 3 coats of epoxy for a solid seal up.
The same boat, in somebody else's shop.