Glen-L Hot Rod

1. The trailer was disassembled and body filler was used to smooth out the frame rails.

2. A self-etching primer and a urethane primer-surfacer were sprayed on the worked-over areas.

3. The primer was block-sanded and prepped for paint.

1. To provide a solid base color for the metallic silver to follow, a full round of Imron white urethane was applied. Two rounds of Imron metallic silver were applied once the white had flashed off.

2. With the main body of the trailer completed, it's time to finish up the inner fenders.

3. The seam was brazed with an oxy-acetelyne torch and ground smooth.

4. Body filler was applied to the inner fenders and air-filed smooth.

5. Fenders get a prime coat of Dupont DTM urethane etching primer.

1. Fenders get a prime coat of Dupont DTM urethane etching primer.

2–3. Primed fender steps.

4. A white base coat is applied to kick up the topcoat color. Several rounds of Imron metallic silver complete the job.

5. We detailed the bunk supports as well.

1–2. Here's the finished product. The fenders and tongue will be painted at a later date since they'll likely get scratched up when the topside of the boat is being finished.

3–4. For added safety, boat/trailer packages exceeding 2000 pounds require electric or hydraulic brakes. The hydraulic unit shown is equipped with a reverse lock pin to prevent brake actuation when backing up the trailer.

1. Laminating the fender steps. 1-1/2" wide by 1/4" thick mahogany strips were epoxied to two pieces of 1/4" marine grade plywood which were previously fitted to the fender steps.

2. Plank spacing was 1/4". Wax paper strips were used under the hold-downs to prevent them from sticking to the lamination.