boatbuildlog

Northeaster Dory · new build

Northeaster Dory to be assembled in Cologne Germany

It is the first boat I build. I‘ll do it in my single garage and partly in my cellar.

Make a book Feed The whole log, 23 entries and every photo, laid out as a book to print, bind and keep.
23
Entries
121
Hours
32
Days elapsed
65
Photos
Oct 2026
Started
Watch the 30 second boat build video

The film on its own page

Hull Exterior · compare · other boats 1.5 h Link

No more bubbles?!

First aid for the Dory. I found an injection and thought let’s give it a try to fill the bubbles with epoxy to assure some solid connection to the hull. After injecting the epoxy I put a heavy bucket on top. Hopefully it works out well. Afterwards I started to cut the edges of fiberglass on the joint between panel 1&2. It is pretty to cut it that close to the edge that all the masking tape is easy to peel off.

1 Northeaster Dory: No more bubbles?!
2 Northeaster Dory: No more bubbles?!
Deck & Coamings · compare · other boats 1 h Link

Mast thwart

Just spent a few minutes in my workshop today. Took some care of the mast thwart. The upcoming days the progress will be smaller. Since today I am back at work so there is not so much time to work on the boat.

Glassing & Epoxy · compare · other boats 2.5 h Link

Flea Market instead

After another great night out my alarm clock woke me up at 8:00 am. I planned to get the skeg fixed to the bottom, shape the rails and find the right position for the dagger board hole. I was just able to finish cutting the rest of the fiberglass along the joint of panel one and two. At this moment my daughter showed up and asked if we could go to a flea market. How could I say no. Back from the market I cut off the ends of the rails at the transom and shortend the rail on the bow. I tried to sand of a bit of the left rail as mentioned in the manual, but the belts of the belt sander seem to be old and started breaking exactly at the seams. Running out of sand belts I went fore a run with Mike. Round about 00:00, Mike and I had spent some time at an art galerie, we had a last beer in the kitchen. Afterwards I decided to give the rudder, the mast step and the skeg a third coat. That was the first time I gathered some experience with the foam brush. I am looking forward until the coat is drie. If it stays that shiny, like it was now, that would mean a quite good result. Let’s see if I can get more things done tomorrow.

Others building the Northeaster Dory

The same boat, in somebody else's shop.

All Northeaster Dory logs, with the medians